strand
Chains of short rods, printed as if by two plates that slipped apart. Each chain wanders across the sheet and now and then splits in two. Its rods are torn, lopsided shapes with a notch at every joint. The plate underneath shows as a thick rim on one side of each rod and a hairline on the other. The fill on top breaks up near its edges into specks, streaks or a dot screen.
strand renders a Loop: 36 frames at 12 fps, in which every chain, with both its plates, drifts once round a small circle. The rod shapes, the plate slip and the specks in the fill hold still, so the rods slide under them. The chains are already shifted at frame 0, so frame 0 differs from the Still. Its site page is playgrnd.tools/strand.

Seed 1, rendered by:
tirage derive --seed 1 --tool strand | tirage render --size 540x960 -o strand.pngThe same Seed 1, encoded at 360x640 by:
tirage derive --seed 1 --tool strand | tirage encode --size 360x640 -o strand.mp4Parameters
Section titled “Parameters”From tirage tools, without the 11 shared dither and grain Parameters:
strand 36 frames count 1..=40 step 1 len 3..=90 step 1 wander 0..=1 step 0.01 branch 0..=1 step 0.01 thick 0..=1 step 0.01 rod 0..=1 step 0.01 notch 0..=1 step 0.01 rough 0..=1 step 0.01 offset 0..=1 step 0.01 edge 0..=1 step 0.01 tex 0..=1 step 0.01 texKinds Stipple, Drag, Screen [no Taste] grain 0..=1 step 0.01 [no Taste]A Seed draws every Parameter above grain. count sets how many chains there are and len how many rods each one lays. wander is how far a chain turns at each rod and branch how often it splits. thick sets the rod width, rod its length and notch the gap between rods. rough tears the edges and makes each rod lopsided. offset is how far the plate slid and edge how much fatter than the fill it is. tex is how much of the fill fails to print, and texKinds the shape of the gaps: loose specks, streaks dragged one way, or a dot screen. grain is strand’s own noise along the edges and over every pixel, not the shared grain pass. It stays at 0.42.
A Seed keeps count between 4 and 20, len between 6 and 32 and thick up to 0.8. Long chains of thick rods cover the whole frame in fill. Every other Parameter can take its full range.
The Palette has 3 inks by role: Ground, Plate and Fill. strand takes at most 3. With 2 inks, the fill prints in the plate ink, as it does on the site.